Mixed Signal In-Circuit Functional Testers - QT-8200M

QT8200M comes with large device library written in QDDL / VHDL and PythonTD languages for In-Circuit and out of Circuit Testing of devices. While testing devices in-circuit, QT8200M employs the auto-compensation technique. 
When any of the inputs are linked together or connected to the power pins, the drive pattern or Test Vector is modified on the fly depending upon the In-Circuit links of the device under test.
The Qmax simulator simulates the output response on the new modified test vector. This is essential to avoid any clash between the pin drivers driving these pins with different logic levels at the same time.
QT8200M can test any Digital device in in-circuit for its functionality using library defined test patterns. The ICFT mode allows interactive testing of the individual devices, as well as whole board, comprising various devices. Clock Terminator test avoids False Alarm and ensures highest possible fault coverage on a wide range of boards.
QT8200M offers powerful Automatic Guarding Guide, while testing a BUS device such as Tri-state / bidirectional/ O.C. / O.E. device, it is required to guard the device under test by disabling other BUS devices present in the BUT which are on the same BUS.
QT8200M has auto guarding facility which lists the IC and the pins of those devices which may need to be guarded.
Trace Links Wizard makes auto guard list correction much simpler. QT8200M can perform an in-circuit clip-on test for analog devices. Using its three built-in true analog channels, QT8200Mdrives true analog patterns to the input pins and senses the analog voltage at the output pinto give a clear Pass/Fail message. User needs to only clip-on & type in the part number of the device to be tested.
QT8200M has a powerful evaluation engine to test linear devices in-circuit, without the need to learn from a known good board.
QT8200M also offers QSM VI technique to test custom devices passive components on a board which cannot be functionally tested in the ICFT mode. QSM VI takes traces by driving a user defined current limited sine wave between any two nodes of the DUT and plotting the voltage Vs current trace.
Auto “Best Fit Curve” for QSM VI automatic selection of best source impedance, voltage and frequency of the VI stimulus.
RLCV measurements.
Frequency measurement up to 130 MHz.
3 channel Digital Oscilloscope and Function Generator.
Powerful “Board under Test” Power Supplies for testing large ECL boards often requiring 20A and more current.